Tein Standard Springs

TEIN Standard Springs
  • To install the standardized springs,
    please use the height adjustable parts
    (sold separately), or use TEIN's
    height adjustable shock absorber kit.
    Please refer to each page for details.
  • All of TEIN's standardized springs are
    ground on both ends and come painted black.
  • TEIN uses SWOSC-KV silicon chrome metal (JIS standard) to pursue the maximum amount of high tension and endurance for all standardized springs.
  • Stability, endurance, and high performance is maintained by special procedures (cooling formation).
  • The straight type springs are measured by inner diameter. and, the specified spring seat is required.
  • The outer diameter changes with alignment.

TEIN Staight Type Springs

TEIN Tapered Type Springs

  • These springs are tapered and the bottom diameter is I.D.70mm, with two types of top diameters of I.D.90mm, I.D.100mm. These are standardized springs which have been developed to adapt with original upper mounts for original double wishbone and multi - link suspension system. Tapered Type Springs have the following outstanding characteristics.
  • Ideal for N1 racing and other vehicles whose upper mounts cannot be replaced under regulations.
  • By eliminating the upper spring seat, we have achieved low cost and adequate bump stroke.
  • It eliminates the damage to upper mount and other noise by maintaining the same force input positions as original products.
  • As it is tapered, spring stroke can be maintained better than the straight type with same spring coefficient and length.
Tein Site Map: Import Tuning JayDM
Standard Springs Stech Springs Htech Springs EDFC Htech Springs Super Street Damper Type Flex Damper Type Wagon Damper Type CS Damper Type HA Damper Type HE Damper Type HG Damper Type HT Damper Type N1 Damper Type RA Damper Type RE Damper Type RS Damper Pillowball Tension Pillowball Mount
  • By setting 2 springs in a series, variable spring rate can be achieved.
  • It gives unlimited setting range with wide winding point weight set ups.
  • The A spring is a series twin spring, and the B spring can be selected from straight type with I.D.70mm or tapered type springs. A variable spring is achieved through changing over from original spring rate to B spring rate.
  • The spacer spring seat is necessary for installation with the A spring.
  • 1. Normal Type
  • 2. Square Type

TEIN Twin Spring Series